HCIA-Datacom V2.0
Read questions, check verified answers and discuss the reasoning. Use reading options to shape your revision, or switch to the simulator for timed practice.
56 questions in this view
On the campus network shown in the figure below, the core switch Core1 functions as a Layer 3 gateway and as a DHCP server to dynamically assign IP addresses from an interface address pool to AP1, PC1, and PC2. The network below Core1 is a Layer 2 network. WAC1 and R1 are connected to Core1 at Layer 3. AP1 goes online through VLAN 100. VLAN 101 and VLAN 102 are respectively used for the wireless and wired services. Additionally, the direct forwarding mode is used for wireless traffic forwarding. When configuring a DHCP server for AP1, you need to run the dhcp server option _____ sub-option 2 ip-address 172.16.12.1 command to specify the WAC1 address. (Enter only digits.)
During VLAN planning for a campus network, VLAN IDs for different service types must be allocated consecutively, without redundancy, to prevent omissions in future allocations.
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
Which of the following are parameters of the set_missing_host_key_policy() method in the Python Paramiko module?
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
The gateway of a PC is on the directly connected switch. If the configuration is correct but the PC cannot ping the gateway, you can replace the network cable between the PC and the switch to check whether the fault is caused by the cable.
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
An enterprise has deployed a Huawei WLAN, but some STAs cannot associate with wireless signals. To troubleshoot this issue, you log in to the WAC and run related commands. The command output is as follows. According to the command output, which of the following is the possible cause of the STA association failure?
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
A micro-enterprise is deploying a WLAN, as shown in the figure. The WAC and Fit APs communicate with each other at Layer 3. SW2 functions as a DHCP server to assign IP addresses to Fit APs, with VLAN 100 as the management VLAN. The figure also shows part of the configuration on SW2. However, Fit APs fail to go online. Which of the following is the possible cause?
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.