Basic Coatings Inspector (Level 1)
Read questions, check verified answers and discuss the reasoning. Use reading options to shape your revision, or switch to the simulator for timed practice.
60 questions in this view
Which of the following are methods for a Coating Inspector to check the salt content on the surface of a substrate?
SELECT TWO (2)
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
What is the true DFT using the data below?
Type 1 DFT gauge reading = 150 microns (5.9 mils)
Base Metal Reading (BMR) = 12 microns (0.5 mils)
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
As per SSPC-PA 2, when using the Type-1 DFT Instrument, the coating inspector should do which of the following?
SELECT TWO (2)
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
Which of the following is best to apply over inorganic zinc to seal the porosity?
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
The form of corrosion that has the largest potential for unexpected catastrophic failure is:
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.
On airless tips, what information does "521" mean when holding the gun 12 in (30 cm) from the surface?
SELECT TWO (2)
Select an answer above, then submit your vote. Reading or practicing does not cast a vote.